- After the installer’s measured up, given you an estimated output and recommended some systems for you, they’ll arrange date to come to your home to install the solar thermal panels. They’ll also let you know if any scaffolding will be required.
- Next, they will start to fit the panels, or collectors, to your roof. Stainless steel brackets will be provided with the system and they will remove your roof tiles or slates to attach the brackets to the rafters. They’ll then replace the tiles and add waterproof flashing to ensure you don’t get any roof leaks, and add the frame.
- If you’ve chosen evacuated tube solar thermal panels, the installer will bolt the heat transfer unit to the top of the frame but not install the tubes until nearer the end. This is because the tubes start to transfer heat to the exchanger immediately, and when everything is unconnected this could damage the unit.
- If you don’t need a new boiler with your installation, a new dual coil water cylinder, pump and system control system will be fitted. It’s best in a loft or upper floor of your home.
- A new thermal store or hot water tank that will store the heat provided by the solar system is much larger than a standard tank but it may fit in the spot of your old one. The installer will ensure that it’s connected to the mains cold water, your other heating source (such as a gas boiler or biomass boiler), immersion heater, temperature sensors and the solar collectors themselves.
- Next they will install the pumping station, usually near the water tank. The expansion tank will be installed on the solar thermal loop, which is usually nearby. Its job is to prevent pressure changes that could damage the system.
- You’ll get a heat generation meter which must be MCS-certified if you want to take advantage of the RHI, and any control equipment that comes with the system will be installed.
- The installers will then bring the system to pressure by pumping the heat transfer liquid into the system up to a pressure of around 2 bar.
- Finally, your MCS-registered installer will register your solar thermal system so you can apply for RHI payments of up to £525 per year. So that’s the process of installing solar thermal panels. Remember – it's always best to use a professional to install any kind of renewable technology.
Wandsworth
The London Borough of Wandsworth is a London borough in England, and forms part of Inner London. The borough borders the London Borough of Lambeth towards the east, the London Borough of Merton and also the Royal Borough of Kingston Upon Thames to the south, the London Borough of Richmond upon Thames towards the west and towards the north, across the River Thames, 3 boroughs, namely the London Borough of Hammersmith and Fulham, Royal Borough of Kensington and Chelsea along with the City of Westminster.
It covers a total area of around 13.23 square miles. As outlined by population estimates produced in the middle of 2014, the borough has a permanent population of around 312145 individuals. You'll find many new or refurbished buildings along the borough's prosperous riverside like the large Chelsea Bridge Wharf.
The Peace Pagoda, one of several such international Pagodas is in Battersea Park, a sprawling rectangle often hosting circuses beside the Thames. The London Heliport, London's principal and busiest heliport is just beyond Battersea Park and south of this is New Covent Garden Market. In Old Battersea two masonry mansions survived The Blitz, Old Battersea House and Downshire House, both of which hold the uncommon Grade II* status.