- After the installer’s measured up, given you an estimated output and recommended some systems for you, they’ll arrange date to come to your home to install the solar thermal panels. They’ll also let you know if any scaffolding will be required.
- Next, they will start to fit the panels, or collectors, to your roof. Stainless steel brackets will be provided with the system and they will remove your roof tiles or slates to attach the brackets to the rafters. They’ll then replace the tiles and add waterproof flashing to ensure you don’t get any roof leaks, and add the frame.
- If you’ve chosen evacuated tube solar thermal panels, the installer will bolt the heat transfer unit to the top of the frame but not install the tubes until nearer the end. This is because the tubes start to transfer heat to the exchanger immediately, and when everything is unconnected this could damage the unit.
- If you don’t need a new boiler with your installation, a new dual coil water cylinder, pump and system control system will be fitted. It’s best in a loft or upper floor of your home.
- A new thermal store or hot water tank that will store the heat provided by the solar system is much larger than a standard tank but it may fit in the spot of your old one. The installer will ensure that it’s connected to the mains cold water, your other heating source (such as a gas boiler or biomass boiler), immersion heater, temperature sensors and the solar collectors themselves.
- Next they will install the pumping station, usually near the water tank. The expansion tank will be installed on the solar thermal loop, which is usually nearby. Its job is to prevent pressure changes that could damage the system.
- You’ll get a heat generation meter which must be MCS-certified if you want to take advantage of the RHI, and any control equipment that comes with the system will be installed.
- The installers will then bring the system to pressure by pumping the heat transfer liquid into the system up to a pressure of around 2 bar.
- Finally, your MCS-registered installer will register your solar thermal system so you can apply for RHI payments of up to £525 per year. So that’s the process of installing solar thermal panels. Remember – it's always best to use a professional to install any kind of renewable technology.
Lambeth
Lambeth is a London borough in south London, England, which forms a part of Inner London. Its name was recorded in 1062 as Lambehitha, translating as 'landing place for lambs', and in 1255 as Lambeth. The borough covers a total area of approximately 10.36 square miles. Lambeth is a long, thin borough, being about three miles (4.8 km) wide and seven miles (11 km) long. Brixton is its civic centre, and you'll find other town centres.
The biggest shopping locations are (in order of size) Streatham, Brixton, Vauxhall, Clapham and West Norwood. The borough is the home of the geographical centre of London at Frazier Street close to Lambeth North tube station. Based on population estimates made during 2014, Lambeth has a permanent population of about 318216 people. Despite the borough's population density, Lambeth has open spaces. They include Brockwell Park and Lido, Streatham Common, half of Clapham Common, West Norwood Cemetery, Archbishop's Park, Norbury Park, Vauxhall Pleasure Gardens and Ruskin and Kennington Parks.
Along and around the South Bank, a tourist area has developed about the previous Greater London Council headquarters of County Hall and also the Southbank Centre and National Theatre. Also around the river is the London Eye and Shell Centre. Nearby is St Thomas' Hospital, Lambeth Palace plus the Florence Nightingale Museum. A landmark within the centre of the borough is the Art Deco Sunlight Laundry on Acre Lane. Nearby is Brixton, home of Lambeth Town Hall as well as the Brixton Murals.