Damp Proofing in Burntwood
Extensions such as garage conversions will usually require supplementary damp proofing to be added through the conversion, as the pre-existing garage normally has a single skin design for walls and floors, which was not designed to conform to building regulations for habitable rooms. This damp proofing should be put into walls and floors. In addition, the roof of the garage conversion will need water proofing. The damp proofing of the floor of the garage conversion will in most cases be achieved by utilising a damp proof membrane. This membrane can come in either solid or liquid form. The damp proof membrane will be put down either on top of the pre-existing concrete floor, below the new floor, or as part of both, depending on if the floor will be a solid or a floating floor. In some garages, the walls have already been damp proofed, but this might have to be updated as part of the conversion to be able to comply with current building regulations. The walls will need to be damp proofed in order to safeguard the brickwork from rotting gradually as moisture sets in. This is carried out by either utilising damp proof membranes, waterproof rendering, or cavity insulation, depending on the type of walls already present in the garage. Damp proofing is a part of the building regulations that the garage conversion should comply with, therefore is it necessary to ensure that your garage conversion incorporates appropriate damp proofing methods.