Find a Builder you can trust near you.

There are so many benefits that comes with building a porch in your home premises. It’s an extra space where a lot can be achieved such as drying a dripping wet dog, taking off your dirty shoes or boot and lots more. So if you’re considering to construct a porch, it’s definitely going to be a wise decision. However, before you get started, there’s a need to determine if you’ll need planning permission for a porch. It’s important to take note that planning laws are dynamic and can be updated at any point, so be sure only to use trusted sources only as your guide. If you’re the homeowner or landlord, it’s entirely your responsibility to obtain the right approval for any development project you wish to carry out within your premises.

A Porch can not be termed as an extension and neither is it a conservatory, they’re basically built to the home’s front covering the main entrance using a stone base or a brick. As a result, a porch does not need planning permission due to the fact that it’s covered by the permitted development rights if the specific guidelines for porches are complied with. Below are the instances where you WILL need planning permission for a porch.

✓ If the floor space is more than 3sqm (the wall inclusive).

✓ The highest point has a height of more than 3 metres.

✓ If the porch is situated within 2 metres of a boundary directly facing on to the road.

You may need planning permission if the house is a listed building, designated area or falls under an Article 4 Direction.

In order to build a porch without planning permission, you need to consider all the criteria stated above. You can also visit the Planning Portal website to get more detailed information before getting started.

Pebble dash is an effective way to tune up your house or property as it can go a long way to enhance its curb appeal while also add to its resale value if you should decide to sell later on. Although, it’s highly recommended to leave this task for a reputable specialist, it’s also something that can be done as a DIY task. It must be states that this is a pretty difficult job and even more so if you haven’t attempted it before. In this post we’re going to take you through the processes involved in pebble dashing a wall. Let’s take a look!

• Mix up water with the lime strictly following the manufacturer’s instructions. Once done, leave it covered up to hydrate for at least 24 hours.
• Take one part of the slaked lime and mix it up with cement and six parts sand. This is to give the base mixture required to spread onto the surface.
• Use a trowel to apply the mixture onto the wall. Ensure that the trowel is level and use the edges to make a flat and smooth layer of the mixture on the surface as a base layer. Allow the base layer to dry for up to an hour. Then, rake the surface using a notched trowel and allow to dry for a minimum of 24 hours.
• Rinse and drain your pebbles. Then, set them under the wall you’re pebble dashing.
• Take the top coat of five parts sand and mix with one part cement and one part slaked lime. Use a trowel to apply this mixture over the base layer and smoothen it with the trowel to create a flat and even top layer.
• Spread a plastic sheet beneath the wall you’re pebble dashing to capture any loose pebbles as they fall.
• Grab the bucket of pebbles below the wall and scoop some of the pebbles up using a scoop or trowel. Some will stick and some will fall into the plastic sheet already placed below. Continue throwing the pebble dash until the surface is completely and evenly covered with pebbles.
• Lightly press and fit the pebbles on each section into the wall and leave for at least 24 hours to dry.

A double house extension is basically a construction to any aspect of your house that elevates up to offer two floors of space. It can be structured to suit your existing home in two storeys or as a side wing on a taller property. If you’re considering building a double house extension, then estimating the cost is a very important task to do before commencing the project. In this article, we’ll give you an idea of the cost of a double house extension so you can estimate yours accordingly.

The double house extension cost depends on several factors that’s specific to your home as well as your design choice. These includes:

• Location of your property. Places like London and the southeast will generally cost more than the other regions due to higher demands.

• Accessibility of the site. The ease of your site’s accessibility also plays a key role in the price.

• Size of the extension. The more the extension’s size in footprint and square metres, the higher the possible costs.

• Materials used in making the roof as well as the complexity of the roof design.

• Your choice of finishing. These includes flooring window and door frames, glazing, underfloor heating and roof lights.

• Your property’s soil type. Different types of soil requires varying treatments as well as materials to develop solid foundations.

Constructing a double house extension is a quite simple build in terms of technicality when its to the side or rear of your house as this can also help you save some money. Generally, considerably expanding your home’s space by building a double house extension will cost within the range of £1,500 per m2 to about £2,800 per m2.

How To Plasterboard A Brick Wall

Do you want to cover your brick wall with plasterboard? The key to success here is the preparation. You must ensure that brick wall is prepared well enough to receive the plasterboard. To get started, there’s the need to attach wood furring strips to the wall which serves as studs in a wood frame structure. This way, the plasterboard will be prevented from getting in touch with the brick. You can always hang pictures or any other forms of decoration in between the gap between the walls. Let’s have a look!

lAttach Furring Strips

• Get a 2 inch by 4 inch wood stud and apply a bead of construction adhesive.

• Using a masonry bit, drill a pilot hole through the wood stud’s base as well as the brick wall.

• Hit a 3 inch fluted nail through the hole using a sledgehammer

• Using a construction adhesive, bind a horizontal 2 inch by 3 inch stud to the upper edge of the wall.

• Using an adhesive, bind the length of a 2 inch by 3 inch stud on its wide side.

• Use a masonry drill to drill a hole on the wood stud and 1 1/2 inches into the brick wall.

• Hit a 3 inch fluted nail through the pilot hole.

lApply Plasterboard

• Hold a plasterboard sheet against the furring strips.

• Use plasterboard screw to hold the drywall sheets in place.

• Use fibreglass to cover the joints where the two plasterboard sheets meet.

• Use a thin layer of the joint compound on the tape. Once done, screw it using a 6 inch taping knife, then allow to dry overnight.

• Use a sandpaper to smooth the joint compound.

• Use a fresh coat of the joint compound to block the holes and joints. Once done, allow the compound to dry.

• Use a light sandpaper to smooth the final coat.

Plasterboarding a brick wall is a simple task but the preparation part must be done right to protect your investment. Therefore, we’d recommend you hire the services of a skilful professional, who can guarantee the best results especially if you lack enough training and experience to carry out a DIY project.

How Much Does It Cost To Have A Loft Boarded?

More often than not, several homeowners fail to realize there’s so much value sitting right under their roof - the loft. When a loft is boarded, there are so many juicy benefits that can be derived. It can be used as a storage room, spare bathroom, home office and several more functions. Therefore, if you really wish to maximize the space under your home’s roof, you’d have to considering boarding it. So how much would it cost to have your loft boarded? Here, you’ll discover the cost of boarding your lofts so you that you can set a budget and start to plan.

The cost of boarding a loft is actually affordable for several individuals, simply because you’re allowed to floor as much or as little as you require. And while you’re up there flooring and fitting the loft boards, you can as well decide to upgrade the insulation of the loft too. This way, you be able to prevent heat from escaping through the roof of the house which helps improve energy efficiency and ultimately, save you some money on heating bills.

If you’d prefer to make it a DIY project, the cost of 18mm chipboard is about £8 to £10 per sheet sized 2400m x 600m. Meanwhile the insulation boards should range between £18 to £22 for a sheet.

For a professional service, you’ll be provided with a quote for both the materials and labour. The amount will be based on the number of boarding required as well as the method selected. For an average storage space needs, flooring size of about 15m2 is suitable. The price for this quantity would be between the range of £50 to £700 for the counter barren method or above £1000 for a more sophisticated method.

Have you been advised by a structural engineer or a surveyor that your building needs to be underpinned? Well, this might just have you wondering what underpinning really is and how long it lasts. In this post, we’re going to tell you more about underpinning to help you make the best-informed decision possible moving forward. Let’s take a look!

Basically, underpinning refers to the incorporation of one of various methods to reinforce or repair the old foundations of a building or structure mostly to remedy or avoid subsidence. Now, subsidence can be caused as a result of poor soil quality, increase in the load on the foundation like adding a new storey, excavations below the building as well as inadequate foundation which is more common in older buildings. When an underpinning remedial work is carried out, there are a plethora of benefits that comes with it. It’s preserves the structural integrity of your building by strengthening it, make it a lot more attractive, increases the property’s value and makes it a lot safer for both you and your loved ones. So how long does underpinning last?

Well, many underpinning contractors will offer you a 10-year guarantee of its underpinning solutions for defects. Primarily, there are two reasons why underpinning can fail which is poor installation and fresh issues arising or unforeseen circumstances. While the first is an issue that can be avoided by employing the services of an expert contractor who possesses vast experience and knowledge in the field, the second can not be avoided. However, in the absence of the unforeseen issues, underpinning is expected to last for the natural life of the building, so far it has been expertly installed.

We all need a reliable place to keep our clothes or dresses, however in situations where a standard freestanding wardrobe just won’t cut it, there is the need to put into consideration a fitted wardrobe. For instance, if you have a bedroom with acloves and sloping ceilings, you’ll discover that the standard-size, freestanding wardrobe just won’t be suitable as they’ll appear strange and look very much out of place while also not being able to put the available space to efficient use. In this regard, a fitted wardrobe will do a much better job as it’s a lot more suitable for mostly all types of bedrooms. So if you’re thinking about having one fitted in your bedroom, you’d probably want to know the just how much it’ll cost. In this article, we’re going to provide you with a good insight on fitted wardrobes cost.

Generally, the prices of fitted wardrobes depend largely on a number of factors. These variables include both the quality as well as the type of included fittings. The types of fitted wardrobes with their estimated price range are given below:

✓ Bespoke fitted bedroom wardrobe. This type can range between £2500 to about £3000 depending on the design details. The extras include mouldings, columns and panels.

✓ Simple two section closet. This type can range between £2500 to about £3200 depending on the design.

✓ Large bedroom, three section, six doors. This type of fitted wardrobe features both interior and exterior finishes alongside drawers and hanging space. The cost normally ranges between £4400 to £4900.

✓ Contemporary, sliding door fitted wardrobe. This type usually features three sections alongside door mirrors to make the bedroom appear larger. The cost normally ranges between £2800 to £3600.

Over the years, garden rooms have gradually become a popular choice amongst homeowners as a cost effective way of expanding living space within a home or property. A garden room is basically a living space and a type of pavilion building made from wood that’s well insulated, double glazed as well as electrically wired. It’s however a building which is subsidiary to the main one, built with the purpose of creating an extra functional space within the property. These garden outbuildings are very functional and can be used as a garden studio, office, salon and much more. They can also be incorporated for recreational purposes for evening relaxations, family and friends get-together, lounge or even spa. Other possible uses of a garden room include gyms, pool houses, playrooms, dens, home cinemas and game rooms.

Garden rooms are functional living spaces that are usable throughout the year. And with the rate at which their popularity is growing, you’ll find some companies offering cheap and low quality alternatives featuring shed like construction and felt roof. Garden rooms, on the other hand, are a valuable investment with superior designs and top notch build. They’re constructed in a very similar way to houses with timber frames. Furthermore, they are fully insulated and can also include the normal building solutions such as heating and running water, electricity and many more depending on the requirements of the home or property owner. With the durability of garden rooms being a major objective, they’re typically clad in natural solid timber like Cedar, Larch or Acacia. Materials such as EPDM rubber or cedar shingles are normally used for the roof covering. What’s more? They usually have large expanses of glazing and glazed doors fitted.