Find a Conservatory Installer you can trust in Fairford.

How To Put A Tiled Roof On A Conservatory

The roof is a vital part of any structure as it protects it from the elements such as snow, rain and lots more. When you have a conservatory built, the roof is just as important as that of the rest of the house. After all, both you and your loved ones will spend a lot of time there over several years, so you can as well give it a proper protection from the elements. So if you’re thinking about installing a tiled roof on your conservatory by yourself, you’ve come to the right place! However, it must be said that this is no easy task and should not be attempted as a DIY task if you do not have a proper training or the confidence needed to pull it off.

✓ Due to the fact that there are a wide range of tiled roofs to choose from, you have to think about the type of tiled roof you need before you proceed. The basic ones include composite panels, slate, synthetic tiles as well as concrete tiles.

✓ Examine the framework. It’s important to make sure that the framework possesses the right structure before adding theroof

✓ Remove the old roof panels. There’s the need to remove the poorly insulated glazed conservatory roof before installing the new tiled roof for a great efficiency.

✓ Change the existing roof frame. Apparently, there’s also a need to detach the older roof frame in order to install the new tiled roof. You have to change the old frame to one that’s suitable for the new tiles to be attached to.

✓ Add the tiles. To add the tiles. Simply lay them out across the roof and clipped on. This shouldn’t take that much time since a conservation isn’t a usually a big structure.

A good way to get rid of your conservatory is to sell it. Depending on its condition you may not make much money from it, but it’s an easy and financially viable way to get your old conservatory dismantled and out of the way. If you are replacing it, the installer can easily remove this for you completely.

• The rules only apply to houses – flats and maisonettes are not included
• Only 50% of the area of land around the original house can be covered by extensions, including conservatories, and other buildings
• You mustn’t build the conservatory higher than the highest part of the original roof
• Where the wooden conservatory comes within 2 metres of the boundary, the height at the eaves can’t exceed 3 metres
• A rear wooden conservatory can’t extend beyond the rear wall of the original house by more than 4 metres if it’s a detached house, or more than 3 metres for any other type of house
• For side extensions, for example a lean-to wooden conservatory, it can’t exceed 4 metres in height and can only be up to half the width of the original house

Due to temperature changes, conservatory window seal expand and contract over time which may lead to them wearing out eventually. If you’re facing a similar issue with your conservatory window seal, then you’d probably want to know how you can go about the repair. If yes, then you’ve come to the right place! In this post we’re going to take you through the conservatory window seal repair process. Let’s take a look!

First and foremost, let consider how to determine if your windows needs to be resealed. This is a very simple procedure as a visual check can help identify whether or not the window needs to be resealed. Simply watch out for the area where the windows meets with the frame as well as the point where various sections of windows meet with one another. You should observe whether there’s an obvious sign of wear and tear, gaps and cracks in the seal. If any is found, then your conservatory window seal will have to be repaired as soon as possible. Another important indicator is a draught coming from the window area or visible condensation signs on internal panels of the glass panes.

When it comes to the resealing of windows, it’s highly recommended that you call in a professional. However, if you wish to carry out the task by yourself as an experienced DIYer, then it would be wise to take extra caution. If done the wrong way, this is likely to generate further issues along the road while also allowing more heat to escape your conservation

The short and simple answer to this question is yes, just like other new extensions, you must have a foundation done for your lean to conservatory. In order to transfer the building’s weight to the floor safely, there’s a need to construct a foundation. Without it, the structural integrity of the extension would be heavily compromised. What’s more? While there’s no minimum depth requirement for a lean to conservatory, there are multiple factors that can affect the depth as well as type of the foundation. Let’s take a look!

• The nearby trees. What trees do is to absorb water from the soil which can affect the foundation significantly. When water is absorbed from the soil, the soil shrinks which affects the foundation’s strength. The size as well as type of the tree will determine the extent of the water absorption from the ground.
• The soil’s suitability. The weight that each soil can withstand varies and even more so, when environmental factors have more effect on certain types of soils than others. For instance, chalk is able to drain water away relatively easily which means that nearby trees will only have a little effect on its quality. Clay, on the other hand, shrinks when drying and also retains a lot of water. This means that nearby trees will have huge impact on clay soil which will compromise the structural integrity of the lean to conservatory. Therefore, since changes to clay mostly occur to about 0.75m depth, foundations on the soil should be constructed deeper to compensate.
• Undisturbed ground. Before the foundations are laid, there’s a need to identify grounds that hasn’t been built on and this usually takes a depth of about 1m (this figure may vary especially in regions where drains have been laid).

Aluminium conservatories are really easy to maintain, making them a top choice for many homeowners. Unlike wooden conservatories, they don’t need regular treatment to ensure they don’t deteriorate.

The most you’ll need to do to keep your aluminium conservatory looking great is give the frames and glass an odd wipe with water and a mild detergent to get rid of any occasional dirt.

Conservatories and orangeries look very similar, so it can be hard to tell what their differences are. The main thing that distinguishes the two is the amount of glazing they have.

Conservatories usually have a roof that is made up of at least 75% glass. Orangeries, on the other hand, have roofs that are generally less than 75% glass.

Conservatories also tend to have walls that are made up of at least 50% glass. However, orangeries have glass on less than 50% of the wall area.

Orangeries were originally developed to grow oranges in large stately homes. Their mixture of brick and glazing gave the oranges a combination of plenty of sunlight and shelter.

Lean-to conservatories are often known as Mediterranean conservatories or sunrooms and are a great way to add more living space when you’ve only got a small amount of room to work with. They usually have clean lines, a rectangular shape and attach to the side or rear of your home, which makes them one of the easiest conservatory types to build yourself.

So how do you build a wooden lean-to conservatory? The first step is to decide what you want it to look like. Most lean-to conservatories are constructed of glass and the wood frame, but you can choose to have dwarf walls too. Dwarf walls are low brick walls that are useful if you’re planning to plumb in radiators, have air conditioning installed or put plug sockets in the conservatory.

When you’ve decided what your wooden lean-to conservatory is going to look like, you’ll need to get the materials. You’ll need to choose a hardy wood – oak is the most expensive but also the most durable – and source glass for the windows. You’ll also need to decide on a roof material and work out the correct pitch.

The first step to building your wooden lean-to conservatory is to dig the foundations. You’ll then need to level the earth, then add concrete to the correct height, which should be lower than your property’s existing damp course. Then, you’ll build up to the damp course, which will be your conservatory’s floor level. Don’t forget to make sure it’s even.

If you’re building a dwarf wall, start it from the base and build up to no more than 1 metre high. Once the cement is dry, place external sills on top of the dwarf wall. You’ll then need to secure the frames; start with the one that secures to your property, then do the same for the rest, connecting outwards until they meet from the two sides. Then put up your doors.

Now it’s time to build the roof. This should be simple if you’ve bought your own custom-made kit. Place the roof ridge on top of the frames, then add the roof rafters between the roof ridge and hip bars. Fit your glazing sheets and guttering – it’s important that your wooden conservatory roof has guttering just like your house, otherwise your conservatory roof won’t last very long and could even cause rainwater to rot your wooden frames.

Once you’ve built your wooden lean-to conservatory, all that’s left is to decide on how you want to decorate it. But if this all sounds like too much, get in touch with specialist wooden conservatory installers who will be able to give you a quote for building you a lean-to conservatory.