Find a Conservatory Installer you can trust in Sedbergh.

You might think that all wooden conservatories are the same. But there are actually lots of differences between them, and some conservatories are better than others. One of the most important factors to consider when you’re looking for a wooden conservatory is the type of wood that it’s made from. Generally, there are two different types to look out for: softwood and hardwood. So what wood should be used for a wooden conservatory?

Softwood conservatories are usually made from European redwood or Siberian larch. These types of conservatories are the cheapest wooden conservatories you can buy because the wood grows much faster than hardwoods. However, due to their soft nature, they may only last 7-15 years, reducing their cost-effectivity.

The best wood to use for a wooden conservatory is a hardwood. The most expensive type is oak, but you get what you pay for – it looks fabulous and it can also be coated with a bug and pest-resistant solution to increase its longevity. If you haven’t got the budget for oak, other hardwood options include Brazilian cedar, idigbo and luan, which are still great choices. Make sure you speak to your conservatory installer about the ‘closeness’ of the wood grains, as close-grained hardwoods are said to be the most suitable for conservatories. You should also check that your supplier has strict control of the quality of the wood so can ensure that it’s been well seasoned and prepared for use in construction.

Building a conservatory can be a challenging task. But whether you plan to hire a professional to build your aluminium conservatory or are considering DIY, it’s good to start with a rough idea of how the process works.

It’s essential to begin with a strong conservatory base. The area needs to be measured out carefully and then dug out. You then need to level the earth and pour in concrete. Your damp proof course goes on top of this, preventing rising damp from entering your structure and creating the floor level.

Then, you need to build your conservatory walls. Start by building your dwarf wall, positioning the external sills on top. Next, fix in the frames and hang your doors. Sit your roof ridge on top of the frames, and add the roof rafters.

Finally, you need to fit the glazing sheets and guttering. Once this is all done, your new aluminium conservatory is ready to go!

What Is The Best Material For A Conservatory Roof?

In the past, conservatories normally have just a single roof material option - polycarbonate. However, there are a number of problems that was faced by some of the older models such as overheating, leaking roof, cold spots as well as poor sound insulation. With the great improvement in conservatory roof technology, better models have been developed which have completely eradicated these issues.

In recent times, we now have a wider varieties of materials that are incorporated to make conservatory roofs which are able to perform much better for a longer period of time. While tiled roof are incredibly useful to minimize heat loss, glass roof make use of clever reflective coating to keep the space at a comfortable temperature and modern polycarbonate roofs are now more energy efficient than it has ever been. So picking the best material for your conservatory roof is now a matter of preference.

✓ Glass conservatory roofs. This type of conservatory roof material is the perfect choice if you want a sleek, architectural finish for your conservatory. Not only are they available indifferent shapes and sizes, but you can also choose a large atrium style roof. They are made using solid aluminium frames that works to support the glass units which are thermally efficient and designed to retain natural heat while reflecting the sun’s glare.

✓ Tiled conservatory roof. Tiles roof are able to fit both the shape and size of your conservatory which provides you with a sloping or vaulted ceiling. They come in varying tiled finishes to match any style home like Marley clay, slate grey, pale shingles amongst others. Tiled roof are also called “warm roofs due to their particularly high levels of thermal insulation. They can also be installed quite easily and as quickly as any other conservatory roof options.

The short and simple answer to this question is yes, just like other new extensions, you must have a foundation done for your lean to conservatory. In order to transfer the building’s weight to the floor safely, there’s a need to construct a foundation. Without it, the structural integrity of the extension would be heavily compromised. What’s more? While there’s no minimum depth requirement for a lean to conservatory, there are multiple factors that can affect the depth as well as type of the foundation. Let’s take a look!

• The nearby trees. What trees do is to absorb water from the soil which can affect the foundation significantly. When water is absorbed from the soil, the soil shrinks which affects the foundation’s strength. The size as well as type of the tree will determine the extent of the water absorption from the ground.
• The soil’s suitability. The weight that each soil can withstand varies and even more so, when environmental factors have more effect on certain types of soils than others. For instance, chalk is able to drain water away relatively easily which means that nearby trees will only have a little effect on its quality. Clay, on the other hand, shrinks when drying and also retains a lot of water. This means that nearby trees will have huge impact on clay soil which will compromise the structural integrity of the lean to conservatory. Therefore, since changes to clay mostly occur to about 0.75m depth, foundations on the soil should be constructed deeper to compensate.
• Undisturbed ground. Before the foundations are laid, there’s a need to identify grounds that hasn’t been built on and this usually takes a depth of about 1m (this figure may vary especially in regions where drains have been laid).

Generally, if you want to do a job, you can as well ensure that’s done properly. You may be considering building a small base for an orangery, but no matter how small it is, it just shouldn’t be done to any other than a compliant standard, and that’s whether or not an approval is needed. When it comes to building work which is covered by Building Regulations, you are required to comply (by the law) with the regulations and to make use of one of the two types of Building Control Service available. These includes the Building Control Service given by your local authority or the Building Control Service given by approved inspectors.

Regardless of the service you opt for, you’re going to pay but the preferred service may offer an advice before commencement of the project. The individual carrying out the building work is charged with the responsibility of ensuring total compliance with the regulations. Therefore, if you select to undertake the project by yourself, the responsibility is primarily on you. In the same vein, if you opt for a building company the responsibility would be the company’s, but you should always ensure to confirm this position before commencement of the project. You must also take note that you may be served with an enforcement notice if you fail to comply with the regulations as the owner of the building. So it’s advisable that you choose your builder very carefully.

There are a bunch of elements you may require approval for like the structural integrity, appropriate insulation levels, or the construction of a building over drainage or sewage. In cases where it’s obvious that you’d need building regulations, you can simply submit the building and planning application together at once.

Lean-to conservatories happens to be some of the most versatile and underestimated conservatory styles you’ll find in the market today and little wonder they’re so popular in the UK. Lean to conservatories, also referred to garden sun room, have been an integral part of the English garden for almost a century. Some of the common features of this extension is being spacious, having large expanses of glazing as well as a special low pitched roof. In other words, lean-to conservatories are able to offer extra space while maximizing natural light and can also be easily installed into awkward spaces.

If you’re also thinking about getting a lean to conservatory, then you’d probably want know the numerous benefits that comes with it. In this post, we’re going to consider some of the reasons why installing a lean to conservatory is a smart decision.

1. It’s easily adaptable to most property styles. Possessing simple lines as well as slim slightlines a lean to conservatory can fit several styles of both traditional and modern homes. In fact, the low pitched roof makes the entire structure a lot easier to fit in rather awkward spaces, making them the ideal choice if you’re have limited outside space.
2. It’s very cost effective. This conservatory style happens to be one of the most affordable and cost effective type of conservatory you’ll find around. Due to their simple design as well as structure, both the cost of installation and maintenance can be minimized, saving you some cool bucks.
3. It offers more usable space. Lean to conservatory’s large design and smart design makes it suitable to add an additional usable space to your home or property.

Whilst uPVC is the UK’s favourite because it’s cheap to manufacture and has a number of qualities, there are also options available including aluminium and hardwood. Both are popular for various reasons.Aluminium, as a metal, is the strongest and most durable material available for conservatories. On top of this it won’t rust, warp or crack. Hardwood offers a more traditional appeal and whilst it requires high maintenance levels, is perfect for conservation areas and listed buildings.

A good way to get rid of your conservatory is to sell it. Depending on its condition you may not make much money from it, but it’s an easy and financially viable way to get your old conservatory dismantled and out of the way. If you are replacing it, the installer can easily remove this for you completely.