Find an Asbestos Removal Contractor you can trust in Canvey Island.

What Does Asbestos Cause?

The perfect example of a silent killer is asbestos. Wonder why? From the day of exposure, you might not see any symptoms of the asbestos containing material disease till years later and more often than not, these disease are not treatable. And as dangerous at it is, it’s most likely not something you’d think about on a daily basis unless you’ve been affected by this harmful material or probably someone you know has.

Found in rocks and soils, asbestos have been an important material for manufacturers across the globe for numerous reasons. Not only are they exceptional insulation materials in both electrical and buildings, but they’re also flexible and resistant to heat, chemicals as well as electricity. And due to this fact, they represent a very common material that’s used in automotive parts, construction materials as well as textiles.

Asbestos when disturbed and inhaled for a long period of time can significantly increase your risk for diseases such as lung cancer, mesothelioma as well as asbestosis. Smokers are more likely feel a greater impact as cigarette smoke irritates lung passages which makes it a lot more difficult for the lungs to remove asbestos fibres.

Mesothelioma. This is a form of cancer that affects the lining of the lungs as well as the lining surrounding the lower digestive tract. By the time diagnosed, it’s almost always fatal.

Lung Cancer. This asbestos related lung cancer is almost the same with that caused by smoking and other causes.

Abestosis. This is a serious scarring condition of the lung which usually occurs after exposure to asbestos after a lengthy period. It can lead to shortness of breath, and in some cases, can be fatal.

For some types of asbestos, you are not legally required to use a licensed contractor. However, it’s recommended that you always use one. These contractors will have all the relevant training and knowledge to make sure asbestos is removed safely. The Health and Safety Executive (HSE) is the licensing body.

The surveyors will check the entire property for signs of asbestos. They may take samples which can be taken away for anaylsis. If they find asbestos, they will inspect its condition, what grade it is and advise you of the best course of action to take.

By now, every homeower should be fully aware of the dangers of asbestos due to the fact that it can be found in a wide range of building products from the roofs and walls and right down to the floor tiles. An exposure to asbestos especially when disturbed can be life threatening as it can lead to a plethora of health issues which includes lung cancer, mesothelioma, asbestosis and lots more.

Asbestos are more dangerous when damaged or disturbed, but if they’re found in a great shape and are left undisturbed, then asbestos containing materials poses little to no threats. This dangerous material can be found in a large variety of insulation. And when compared to batt insulation, loose-fill insulation can be highly dangerous when it’s not installed in the right way. When poorly done, several particles of the asbestos can be released inside the wall or around pipes. As a result, insulation becomes a big worry that most homeowers will face down the road.

Homes that were constructed before the 1980’s commonly features steam pipes, hot water pipes as well as furnace ducts insulated with asbestos containing materials. And this is primarily because there’s no other fire retardant, thermal as well as acoustic insulator like asbestos that’s as effective and affordable as it is. However to really know if your building’s insulation is made with asbestos containing materials, you can take the following steps:

✓ Find out when your house was built. If it was constructed or renovated before the 1980’s then it’s likely to contain some asbestos materials.

✓ Although this is not advisable, but if you plan on checking the insulation by yourself, you should ensure to put on protect equipment such as goggles, gloves, masks and a safety suit.

✓ Check for insulation available in the building. The asbestos containing insulation in both batt and loose-fill types are grey-coloured so this shouldn’t be too hard to spot.

✓ Examine the pipe coverings especially the blanket type and cardboard coverings.

There are all different types of Asbestos. Some kinds of asbestos, if they are in good condition, may be left as they are or covered up. If there is any danger of the asbestos being damaged and particles entering the air, it should be removed. Once a survey has been completed you will be advised on what course of action to take.

If you find out there’s asbestos in your property, it’s not always necessary to remove it. Asbestos is relatively low-risk if it’s contained in a material. This means that, if the material it’s in is in good condition, it shouldn’t be a problem.

However, if a material containing asbestos is damaged, or you want to remove, sand or drill into it, it’s best to have it removed by a licensed professional.

If your house is built before the 1980’s it’s likely to contain some form of asbestos material which when disturbed can release some harmful fibres whose inhalation can lead to a number of fatal diseases and health issues like lung cancer and asbestosis. If you suspect that your house contains some asbestos materials, the best step to take is to call in a qualified asbestos consultant to carry out a thorough inspection of the area so as to identify the potential asbestos containing materials in your property.

The result of the testing done will bring a peace of mind as it’ll confirm whether or not the material actually contains asbestos. In the event whereby the testing result shows that the material does not contain asbestos, this will significantly reduce your renovation or demolition cost. So if you’re wondering how asbestos testing can be done, simply continue reading.

Identifying asbestos is as simple as just looking at the material with the naked to check if it contains the harmful substance. The presence or otherwise of a potential asbestos containing material can only be confirmed by laboratory testing. A qualitative identification of asbestos in a bulk sample is the best method for testing for asbestos. This asbestos testing process involves taking a look at the fibres under a polarized light microscope and under varying conditions to determine the kind of asbestos it is, if present. The result of the testing, if positive, will identify the type of the asbestos discovered and this can be either white or chyrsotile asbestos, brown or amosite asbestos or, blue or crocidolite asbestos. However in the event whereby the sample doesn’t contain any asbestos, the test result will show NAD or No Asbestos Detected.

A typical Homebuyer Report or Building Survey Report doesn’t usually involve checking for asbestos. Your surveyor may let you know that there are certain parts of the property that are likely to contain asbestos, but they won’t do any testing. This means that, if you want to be sure about whether a property contains asbestos, you need to get an asbestos survey.