- Prepare the sub-base The driveway company will excavate, or dig, the existing surface down to a depth of around 200mm. They will remove any debris from the area may place it in a skip or arrange for it to be removed in another way. When they dig down to the sub-base of your previous driveway, they will assess how much hardcore they need and arrange for that to be delivered to the site. They will then spread the hardcore across the sub-base to create a level surface to pour the concrete on. Most good contractors will apply a gel to any walls and doors to protect them from concrete splashes. They will also add any gulley tops, manhole covers or shuttering that’s required.
- Installation and imprinting Next, the tradespeople will have the concrete either poured from a large mixer vehicle or barrow it in from a mixer and pour onto the surface. They level it with rakes, then add a colour surface hardener in a colour of your choice. This will give the driveway its permanent colour. They will then wait until the concrete has hardened to the correct consistency for imprinting the pattern, then will use special tools and stencils to make the pattern that you asked for. They will then spread a colour powder called a release agent over the surface, and leave to dry for 1 to 2 days depending on the weather conditions.
- Cleaning When the contractors return, they will add crack control cuts into the concrete. This is important because concrete expands and contracts in the heat, so there needs to be some give to stop any larger cracks from forming. Then everything is power washed clean, and a chemical wash is also used on the concrete to ensure it’s completely dust-free. The installers will ensure all your walls and doors are clean, which will hopefully be an easy job if they used wall gel.
- Sealing The final step is to seal the driveway. There needs to have been at least two dry days before the tradespeople can do it, so you might find it’s best to have your pattern imprinted driveway installed in the summer. The contractors will blow any debris away from the surface and dry any damp areas where necessary. They will then add an anti-slip agent to the sealant and brush it on. It’s best to not walk or drive onto your new concrete driveway for about 4 days after sealing to allow everything to set. But after that, you’re ready to use your new driveway!
Bo'ness
Bo'ness, officially called Borrowstounness, is a coastal parish inside the Central Lowlands of Scotland. Prior to the enactment of the local government reforms towards the end of the twentieth century, it was a part of the county of West Lothian. Lying on a hillside around the south bank of the Firth of Forth within the Falkirk council area, it is 16.9 miles northwest of Edinburgh and 7 miles east of Falkirk. As recorded in the 2001 Census, Bo'ness includes a resident population of roughly 13,961, and estimates in 2008 have indicated that it has increased to roughly 14,490 residents. A large amount of the inhabitants commute to work, mostly to Edinburgh, Glasgow and Flakirk, meaning that the town is largely a commuter town. Among the list of most significant employers is the Ineos petrochemical facility, which is situated by Grangemouth, which is close to the town. Bo'ness has lots of attractions which are well-known with nearby residents and visitors. Some examples include the Bo'ness and Kinneil Railway, the Birkhill Fireclay Mine and also the remains of an engine house. Kinneil House, a original house maintained by Historic Scotland, is positioned inside a public park and the grounds in which James Watt created the steam engine. His workshop remains in ruins. The town also features a recently redeveloped Hippodrome Cinema, the oldest cinema in Scotland, constructed in 1912 and designed by a local architect and resident, Matthew Steele. For all of your house improvement work, ensure that you employ trusted pros in Bo'ness to ensure that you get the very best quality service.